The SRAM Level hydraulic disc brakes
use the reliable design of the Guide brakes, but move from an All Mountain/Enduro focused 4-piston design to a traditional 2-piston design suitable for XC and Trail use. By moving from 4 to 2 pistons SRAM
is able to reduce the size of both the caliper and lever to reduce system weight on the Level disc brake
when compared to the comparable Guide disc brake
uses the same Bleeding Edge bladder design to make bleeding the system a quick and easy process. Level brakes come pre-bled with SRAM DOT 5.1 fluid that provides a higher boiling point over older DOT 4 fluid.
Replacing the Elixir XX disc brakes, Level Ultimate disc brakes offer better power and reliability in a package that is only slightly heavier than the Elixir XX but 42g lighter than the Guide Ultimate disc brakes.
On the lever side of the Level Ultimate, SRAM
uses a carbon fiber lever blade
, Ti hardware and sealed pivot bearings for a smooth and consistent level pull. SRAM's Direct Link
pull ratio provides even power through out the entire lever stroke. Level Ultimate brake levers
are compatible with SRAM
Matchmaker and MMX shifters, lockout levers and remotes. Level Ultimate levers can be used on the Right or Left side depending on your braking preference.
The Level Ultimate
Caliper is also all new featuring a Monoblock 2-piston design. The 1 piece forged design dissipates heat better with increased stopping power or a 2-piece caliper design. Level Ultimate disc calipers come with SRAM Organic Compound pads
with alloy backing plates.
- Pre-bled with 900mm front and 1800mm rear hoses
- SRAM Centerline rotors are recommended
- IS adaptors and rotors sold separately
- 318g with 800mm of hose and 160mm CLX rotor