Paul Comp

Flat Mount Bracket Rear - 160mm

Paul Comp Flat Mount Bracket Rear - 160mm is a purpose-built flat mount disc brake adapter for riders running Paul Comp flat mount calipers on modern flat mount frames while stepping up rotor size for improved braking leverage and heat capacity. Designed as a clean, precise solution for rear brake fitment, it converts a rear flat mount setup intended for a 140mm rotor to accept a 160mm rotor without resorting to generic adapters.

• Rear 140-to-160mm compatibility - built to run a 160mm rear rotor on frames designed around a 140mm flat mount standard
• Flat mount caliper interface - engineered specifically for mounting Paul Comp flat mount calipers to flat mount frames for correct alignment and secure hardware engagement
• Rotor size flexibility - can also be used for other +20mm rotor steps (for example, 140mm on a 120mm mount or 180mm on a 160mm mount) when frame, caliper, and rotor clearance allow
• Included mounting screws (multiple lengths) - supports a wider range of frame mount thicknesses; correct installation requires approximately 5–9mm of thread protrusion for proper caliper engagement