Nitto
B135 Randonneur Handlebar

Question 1

Q.

asked by: a guest
The width is measured "center to center", but center to center *where*? At the top of the bars, or at the bar ends?

not logged-in
log-in to get credit for your answer

canteau · Answer

Nitto's bars are measured differently from model to model. They have a diagram here:

http://nitto-tokyo.sakura.ne.jp/bar-measurement.pdf

Question 2

Q.

asked by: a guest
Will the B135 fit into the Nitto FU-82 Riser Quill?

not logged-in
log-in to get credit for your answer

canteau · Answer

If you have the 25.4mm clamp version it should.

Question 3

Q.

asked by: kristenkey
I typically ride gripping the levers, so how wide are the bars where the levers mount?

not logged-in
log-in to get credit for your answer

kristenkey · Answer

If you are talking about the width of the the bar in between where the levers sit normally, it is 42 cm.

Thanks!

Question 4

Q.

asked by: a guest
Will they accept barend shifters?

not logged-in
log-in to get credit for your answer

t.young · Answer

They should fit fine.

Specifications